Intelligent built-in electronic dimmer touch sensor button lamps motors 230V 1kW

MANUAL

This recessed electronic dimmer allows you to control the power supplied by light bulbs (filament, halogen), motor speed (drills, fans ... etc), electric heaters via a contact that can be connected to a mechanical button or a contact that can be connected to a TOUCH sensor. .

The maximum load is 1kW and is ideal for resistive and inductive loads.

The power is adjusted intelligently with a single mechanical or TOUCH button (not supplied) depending on your installation: by keeping the button pressed, the power delivered gradually rises and falls until the button (mechanical or touch) is pressed and when the button is released, the current brightness is maintained until it is pressed again.

By quickly pressing the button, the device acts as a switch by turning off the load and shortly pressing it again, reactivating it with the last power delivery setting.

By holding down the button perpetually (short circuit), the device acts as a soft flasher with a continuous on and off time of 5 - 9 seconds for up and down power supply.

Power supply from 220V to 240V AC 50 / 60Hz.

The device is installed in a plastic container with a metal rear part that can be installed on a heat sink or metal casing.

SPECIFICATIONS:

• Input voltage: 220-240V AC at 50 / 60Hz

• Maximum allowable current and load: 6A (1kW)

• Power control via single mechanical button or touch TOUCH (not supplied), the choice of the preferred control can be selected during installation

• Intelligent single button control: by keeping the button pressed, the power output gradually increases and decreases until the button (mechanical or touch) is pressed and when the button is released, the current brightness / motor speed is maintained until a new pressure.

• By quickly pressing the button, the device acts as a switch by turning off the load and shortly pressing it again, reactivating it with the last power delivery setting.

• Power delivery setting time with 1 x up and down from about 5 to 9 seconds.

• For resistive ohmic and inductive loads (motors)

• Connection: in series with the load to be controlled with connection via pre-installed wires, two-wire connection for mechanical button, one-wire connection for touch button.

• Power regulation by phase control

• Ideal for built-in

• Dimensions approx. 80 x 56 x 23 mm