AES 3 ZEROWATT STANDBY KILLER ENERGY SAVING SOCKET FOR COMPUTER AND ACCESSORIES
This device allows you to quickly and easily save waste due to the energy consumption of computers and its accessories (PC, NOTEBOOK, MAC, printers and more) when turned off.
You can pay safely by Card, PayPal, Amazon Pay or Bank Transfer
Express shipments with DHL, BRT, GLS
You have 15 days from delivery to return the product if you are not satisfied
This device allows you to quickly and easily save waste due to the energy consumption of computers and its accessories (PC, NOTEBOOK, MAC, printers and more) when turned off. In fact, although the PC seems off it has some components that are always powered, which in the long run lead to a lot of waste of energy and useless money. Not to mention that these components that are always powered, perhaps in your absence, could be a source of fires due to technical problems. Leaving the PC without power when not in use can also lead to a reduction in wear over the years. The device acts directly by disconnecting the PC from the power line when not in use and then reconnecting it only when you want to turn it on again using a convenient wired button command.
All this can be installed in a very simple way as it is sufficient to place the standby killer device between the PC socket and the wall socket and place the device button in a convenient position on the desk.
It is also equipped with a function capable of learning and recognizing the absorption of the PC and disconnecting the power supply only if it is first turned off, avoiding unwanted deactivations.
Place the connected device between the PC and the wall socket, the device is equipped with a SCHUKO socket (German). It is possible to use adapters for sockets.
Place the button control on the desk or in a convenient position as you will always need to press that button before turning on the PC as you usually do. The button is connected to the device via a wire that will allow you to position the remote control.
Once you have done the above, press the button on the device for about 3 seconds.
Now you can turn your PC on and off as you usually do.
With the PC off, press the “learn standby” button on the device for about 3 seconds (it is located on the top socket).
Wait until the indicator LED on the socket comes out of the "learn standby" mode (changes the flashing frequency)
If everything went correctly through the button on the wire you will be able to activate the PC first by pressing the button and then by activating the PC. When you turn off the PC, the device will wait a few minutes and disconnect the power supply, guaranteeing a power consumption of 0W.
Press the button on the wire and turn on the PC as you usually are used to.
When you turn off the PC, the device will wait a few minutes and automatically cut off the power to the PC.
You can also connect the PC accessories to the device via multi socket to ensure a power consumption of 0W even for the PC accessories.
SCHUKO socket (German)
Power supply 230V AC 50Hz
Maximum power of connected devices 2500W (absorption 10A)
Maximum learnable power in standby 70W
Power on control button on cable and standby absorption learning button
Absorption after 0W detachment
Standby PC Auto Detector
Automatic PC disconnection after 3 minutes of standby
Manual in Italian