TDA2616 STEREO 2 X 30 W amplifier KIT for 4 - 8 Ohm 2 x 12VAC speakers

Attention, the product is a KIT and therefore you will be given the components to be welded with an electronic soldering iron and everything you need to recreate the device as shown in the image. The KIT includes easy-to-understand illustrated instructions in English.

LEVELESPEREQUIRED medium-low

The product is also available in assembled and tested version (code VM113)

This small amplifier is built around the TDA2616 integrated circuit, capable of delivering a maximum power of 2 x 15 W rms (into 4 Ohms) and 2 x 10 W rms (into 8 Ohms). The integrated circuit is fully protected against overloads and short circuits. For powering the amplifier, no additional rectifiers, capacitors or filters are required and alternating voltages can be directly connected.

USEFUL LINKSMANUAL AND DATASHEET

Specifications

·        Music output power: 2 x 30 W / 4 Ohm

·        output power (RMS): 2 x 15W / 4 Ohm or 2 x 10W / 8 Ohm

·        Total harmonic distortion: 0.07% (1W / 1kHz)

·        separation between channels: 70 dB

·        frequency response: 7Hz to 60kHz (-3dB)

·        signal to noise ratio: 98 dB

·        input sensitivity: 300mV / 20kOhm

·        suppression of transients at switching on and off

·        overload and short circuit protection: max. 1 hour

·        power supply: 2 x 12 VAC / 2 A (50 W transformer)

·        PCB size: 70 x 50mm