Double photoelectric transducer phototransistor RA RR for Enel Arduino

DATA SHEET

Optical transducer with phototransistor to take the signal emitted by the flashing of the enel meters on the RA and RR LEDs, allowing to take the consumption data in active and reactive power.

Transducer consisting of two photoelectric sensors (phototransistors) capable of acquiring the light pulses of the energy meter and transducing them into electrical signals - Cable length: three meters - IP30.

It can be used with consumption data logger systems and with Arduino boards, in this case it requires a special sketch that converts the flashing back into power.

The sktech for arduino (or similar) is also available upon request to obtain kwh and instantaneous power of the impulse reading of the device LEDs.

FEATURES

•          Double phototransistor for RA and RR LEDs
•          Installation via double-sided tape on the device
•          Three-pole output cable with sheath
•          Connections BROWN active energy collector, BLUE reactive energy collector, BLACK common emitter

SPECIFICATIONS