Rain sensor for Arduino and embedded with detection plate and transducer

Consisting of a base with a large detection area (34x47 mm) on both sides and control electronics, this product is particularly suitable as a rain detector. The electronic section has an analogue output, a digital one, a trimmer to adjust the input sensitivity and two status LEDs. The digital output D0 can directly drive devices with a maximum absorption of 100 mA such as relays, buzzers, small fans, etc. When the detection area is not wet by rain, the digital output D0 is at a high logic level, when it is wet it goes at a low logic level. By connecting the analogue output A0 to the analogue input of Arduino is possible to know the amount of rain that has fallen on the sensor. Power supply: 5 Vdc.

Usable with a rduino and embedded systems available on EBAY | MECTRONICA STORE

SPECIFICATIONS

• 5V DC power supply

• It detects the fall of rain and the presence of conductive liquids

• Plate size 34x47 mm

• Complete with transducer circuit

• Analog and digital output with rain sensitivity level adjustment

• Digital output capable of driving loads up to 100mA