Monostable timer start stop buttons 12V DC adjustable 2sec- 23min with relay output

MANUAL

Compact low voltage timer operating at 12-15V DC with connections prepared for a start and a stop button (not supplied). Output controlled with NO clean contact relay that can control loads of up to 25V 3A (can be increased with the use of additional external relays).

The timer operation is of the monostable type: by pressing start the timer activates and activates its relay output by closing the NO contact, once the time set by means of the appropriate regulation has elapsed the relay output is deactivated by opening the NO contact. The timing can be stopped at any time by pressing the stop button.

The relay activation time can be adjusted from 2 seconds to 23 minutes with an accuracy of +/- 30% by means of a special selector on the device.

Power supply indication and relay output activation via two LEDs.

Attention: pushbuttons not supplied, two NO pushbuttons are required to close the appropriate contacts when pressed If you also need buttons, you can request a quote for the supply.

Do you need the power supply? Find them here: EBAY | MECTRONICA STORE

SPECIFICATIONS

• 12V-15V DC power supply

• Maximum current consumption approx.20mA / 80mA (with relay active)

• Relay output activation timer time adjustable by selector from 2 seconds to about 23 minutes continuously (accuracy +/- 30%)

• Faston connection: 2 start button contacts, 2 stop button contacts, 2 power supply contacts, 2 NO contact output contacts (normally open)

• Buttons not supplied (NO buttons required)

• Power supply and relay activation indication via 2 LEDs

• Output on relay with NO clean contact for maximum load 25V 3A (can be increased with external relays)

• Monostable operation: by pressing start the relay is activated and remains active until the set time has elapsed; by pressing stop it is possible to interrupt the timing and deactivate the relay at any time

• Ideal as a low voltage staircase light timer, for the control of electrical and electronic equipment

• Electronic timing management

• Dimensions approx. 87 x 60 x 33 mm

• Plastic case with fixing holes